How to turn off maintenance light on toyota camry push start

How to reset maintenance light Toyota Camry 2014 Push button start is a bit different from other Camry models without a push button. These steps are valid for all 2014 onward to hybrid push-button start versions.

In case you are looking for other procedures without a push-button start then you can find them in the later section of this article.

Here is How Reset Maintenance Light Toyota Camry 2014 Push Button Start

1. Press the Push Button without pressing the foot on brake, because you don’t have to start your car but to Just Power on.
2. Press the odometer button until “TRIP A” appears on the screen.
3. Turn the ignition “off”
4. Push the Trip A until appear 0000 on the screen, make sure don’t put off your finger from odometer button.
5. And then Press the Push button twice without pressing a foot on a brake pedal and don’t release the Trip A button until its blinking.
6. Release the Trip A Button and, On a small infotainment screen, it appear Resetting maintenance data.

How to Turn off Maintenance Light on the Toyota Camry models of 2007 till 2015 on all Camry version except Push Start button.

1. Without starting the engine, turn the ignition to the on position.
2. Press the odometer button until “TRIP A” appears on the screen.
3. Turn the ignition “off”
4. Press and hold the Trip Odometer Reset button, and turn the ignition switch to the “On” position.
5. Hold down the Trip Odometer Reset button until “000000” MILES appears on the display and the maintenance light turns off.

More: Toyota Sienna Check Engine Light Vsc Trac Off

These steps of How to Turn off Maintenance Light on the Toyota Camry of 2002 till 2007 on all Camry versions.

1. Turn the ignition to position On without starting the engine.
2. Press the odometer button until you see “ODO”
3. Turn the ignition “off”
4. Press and hold the Trip Odometer Reset button, and turn the ignition switch to the “On” position.
5. Hold down the Trip Odometer Reset button until “000000” MILES appears on the display and the maintenance light turns off.

The Toyota Camry will display a ‘Maintenance Required‘ message to remind you that an oil change is due. Once maintenance service has been performed, you can reset the oil light with these steps.

2018-2021 Models

1. Select ⚙️ on the touch-screen, or select ⦿ on the steering wheel (depending on model).
2. Select 
   or “Vehicle Settings” (depending on model), then select “OK“.
3. Select “Scheduled Maintenance” then select “OK“.
4. Select “Yes” then select “OK“.

2007-2017 Models

1. Turn the ignition of the vehicle “On“. On push button models, press the Engine Start button two times.
2. Press the “Trip” or “Disp” button to toggle the display to show the Trip A mileage.
3. Turn the ignition to “Off“.
4. Press and hold the “Trip” or “Disp” button.
5. Continue to hold the “Trip” or “Disp” button while turning the ignition of the vehicle on. On push button models, press the Engine Start button two times. Do not start the engine.
6. When the odometer displays all zeros, it will confirm the maintenance light has been reset.

1998-2006 Models

1. With the vehicle running, press the “Trip” stem button to toggle the display to show the full odometer mileage.
2. Turn the ignition to the “ACC” or “Lock” position.
3. Press and hold the “Trip” stem button while turning the ignition to the “On” position.
4. Continue holding the “Trip” stem button until the display shows all zeros.

The light will display again after 5,000 miles.

I hope this post has helped you reset the oil maintenance light on your Toyota Camry.