2013 kia soul crankshaft position sensor location

1 years ago

Comments: 0

Views: 87

Inspection

1.	Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

3.	Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

1.	Install in the reverse order of removal. Crankshaft position sensor installation bolt: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

See also:

Phone(if equipped)
Before using the Bluetooth® Wireless Technology phone features In order to use Bluetooth® Wireless Technology phone, you must first pair and connect the Bluetooth® Wireless Techno ...

Crash Pad Side Cover Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protec ...

Windshield Deicer Switch Installation
1. Install the heater and A/C control unit. 2. Connect the negative (-) battery terminal. ...

kia soul crankshaft position sensor location